Skip to main content
All CollectionsOur carsEX30 - Quick start guide
Starting and stopping the engine (EX30)
Starting and stopping the engine (EX30)
Tove avatar
Written by Tove
Updated over a month ago

There is no start and stop button. Just press the brake pedal and select the desired gear to drive in. To turn off the car, press the P button on the end of the lever.

Your car won't start? No problem, see tips on what you can think of in the list below:

  • The car's electric drive motor is always prioritized so it can be very quiet when starting, so try holding down the brake pedal and shifting to D or R to make sure the car starts properly.

  • If the engine has not started after 3 attempts – wait 3 minutes before starting a new attempt. Starting ability increases if the starter battery is allowed to recover.

  • The car cannot be started if the charging cable is still in. Pay attention that the charging cable is removed and the charging door is closed before starting the car.

  • If One Pedal Drive is activated, the car will not drive forward, but can roll away if the ground slopes in the same direction as the selected gear position.

  • If One Pedal Drive is deactivated, the car will drift slowly in the selected direction when the accelerator pedal is lightly pressed.

Did this answer your question?